MacSailing.net
MacEnc to Raymarine - Printable Version

+- MacSailing.net (https://macsailing.net/mybb)
+-- Forum: MacSailing.net (https://macsailing.net/mybb/forum-3.html)
+--- Forum: MacENC & GPSNavX (https://macsailing.net/mybb/forum-5.html)
+--- Thread: MacEnc to Raymarine (/thread-1698.html)



- cnojek - March 19, 2012

I have a E90 W Raymarine chartplotter, a miniplex 2 wi Ship Module multiplexer and a Mac Enc software with Navionics charts. The question is: Can I built routes and way points with the Mac Enc and transfer them to the chart plotter?


- GPSNavX - March 19, 2012

Using the USB connection to the Miniplex-2Wi, waypoints should transfer over. Set Type to "Other" in the GPS panel Settings drawer and select the port USBSerial-XXXX, Rate 4800. You will need to install the FTDI driver linked here..

http://www.shipmodul.com/en/downloads.html

Be sure to re-start Mac after doing so.


- Hans Karreman - March 20, 2012

Hi, I have an ST80 system on board and have just purchased an iMUXst multiplexer. Will I be able to transfer waypoints from my MacBook or iPAD to the Raymarine network?


- GPSNavX - March 20, 2012

Yes you can transfer waypoints from iPad using the "Transfer" button in the iNavX TCP/IP NMEA Client view.

Yes you can transfer waypoints from Mac using a USB connection to the Brookhouse iMuxSt using the "Transfer" menu item on the "Waypoints" menu in MacENC/GPSNavX.