February 16, 2009 11:03
illini71 Wrote:I successfully ran MaxSea 10.x in Parallels, but could not get the CMap charts to work. MaxSea would not recognize the CMap charts. I spoke with Jeppesen and they said they would not work in that construct. I sold MaxSea and the charts.
Sounds like I should have tried Fusion.
was bored today so was tinkering with maxsea and CM93 again and finally got it to recognise and open the charts, there's a few of the installed .ini files you have to change, and you have to run through CmapEd2Access thing as well.
only taken me about 2 years to get the thing to work!
not that I'll be using it now, the boat is definately a PC free zone!