• Welcome to MacSailing.net!
  • Dedicated to sailing!
  • Be Jolly!
Hello There, Guest! Login Register

MacSailing.net > MacSailing.net > Hardware > Cutting and splicing a mac mini power cord >

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Title: Cutting and splicing a mac mini power cord
Offline
bobetter
4


***
Posts: 181
Threads: 7
Joined: July 28, 2005
Reputation: 0
#5
May 14, 2010 12:59
It's been a while since I installed a Mini/Carnetix system but to the best of my recollection, you should have a (+) (red), (-) (blk), an iSense (wht) and the shield in the Mac Pwr cable. Don't confuse the shield (ground) with (-). The shield, if connected, should go to a ground, not a (-).

These wires should connect to the Carnetix Molex as per the manual. You will also have to connect the yellow (ign) wire from the Carnetix power input harness to one of the input reds.
 
Reply
  


Messages In This Thread
[No subject] - by - May 13, 2010 13:23
[No subject] - by - May 13, 2010 17:22
[No subject] - by - May 14, 2010 06:46
[No subject] - by - May 14, 2010 11:18
[No subject] - by - May 14, 2010 12:59
[No subject] - by - May 14, 2010 22:58
[No subject] - by - May 15, 2010 07:59
[No subject] - by - May 16, 2010 00:02

Possibly Related Threads…
Thread Author Replies Views Last Post
  Mac Mini sans inverter patrickmast 11 10,238 December 4, 2009 05:19
Last Post: outstripp
  A mini, MacENC and Furuno ginginsman 0 3,487 October 2, 2009 12:25
Last Post: ginginsman
  Mac Mini Power Consumption jagasail 4 7,804 July 26, 2009 14:55
Last Post: Eric Frank
  Mac Mini installation aboard michelb 2 3,281 November 18, 2007 11:01
Last Post: GPSNavX
  Mac Mini EOL GPSNavX 0 2,182 May 24, 2007 12:46
Last Post: GPSNavX

Forum Jump:


Browsing: 2 Guest(s)