September 7, 2010 22:38
Should be as simple as connecting Pin 3 (Data out) and Pin 5 (Ground) then selecting KeySerial1 in the GPS panel Settings panel for Repeat port. Uncheck "Autopilot" only so all NMEA data received into the primary port will be resent to the repeat port. You can view the GPS panel Monitor drawer to see received data and repeated data will be enclosed in brackets. Rate should be 4800.
Do be sure the Keyspan adapter is connected before starting GPSNavX and that the correct Keyspan driver is installed (linked in the GPSNavX help).
p.s. It's actually NMEA-0183 data.
Do be sure the Keyspan adapter is connected before starting GPSNavX and that the correct Keyspan driver is installed (linked in the GPSNavX help).
p.s. It's actually NMEA-0183 data.
Scott Dillon
Sydney Australia
North Shore 38
CYCA
Sydney Australia
North Shore 38
CYCA