May 8, 2011 11:00
Hi Pat,
If it were my boat, I'd run a 4 wire twisted pair cable (18 AWG) from the NX2 RS232 port to the USB-serial converter on the mini. This should do for runs up to 25' without degradation. The DB9 can be soldered (or pin crimped) after you pull the cable through to the mini.
If it were my boat, I'd run a 4 wire twisted pair cable (18 AWG) from the NX2 RS232 port to the USB-serial converter on the mini. This should do for runs up to 25' without degradation. The DB9 can be soldered (or pin crimped) after you pull the cable through to the mini.
— —••• •••— —
Jon Longworth
Jon Longworth