• Welcome to MacSailing.net!
  • Dedicated to sailing!
  • Be Jolly!
Hello There, Guest! Login Register


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Title: Magnetic Variation on COG?
#2
As Applied to MacENC 8.50..

Whether COG or other bearings such as BTW are True or Magnetic are set on the MacENC "View" menu.

You can set the amount of variation manually or let MacENC compute it in the MacENC "Variation" in the Preferences.

The "Instruments" section of the MacENC Preferences applies only to the "Instruments" panel which will either show Heading True or Heading Magnetic.

Every bearing shown in MacENC will either display "True" or "Mag" after it's value.
Scott Dillon
Sydney Australia
North Shore 38
CYCA
 
Reply
  


Messages In This Thread
[No subject] - by - May 27, 2012 15:39
[No subject] - by - May 27, 2012 16:51
[No subject] - by - May 27, 2012 18:33

Forum Jump:


Browsing: 2 Guest(s)