4
Posts: 152
Threads: 48
Joined: June 3, 2005
Reputation:
0
We are currently running GPSnavX on an iBook G4 with a Garmin GPS130 and the NASA AIS engine. It all works okay but I can no longer send waypoints back to the GPS. I could do this before I added the AIS.
Therefore, I am thinking of adding a multiplexer to the system. Which one should I buy? Am I barking up the right tree?
5
Posts: 1,947
Threads: 284
Joined: April 22, 2005
Reputation:
0
The problem is the NASA AIS receiver filters both the Garmin proprietary data (needed to transfer waypoints, routes, tracks) and all but the $GPGLL NMEA sentence. A multiplexer (mux) will not support the Garmin proprietary data, however it will allow ALL the GPS NMEA data to be received.
I would recommend a Shipmodul Miniplex Lite mux. Run the GPS into channel 1 and the AIS into channel 3 and if you have NMEA instruments run those into channel 2 of the mux.
In order to transfer the waypoint information to the Garmin GPS, you need to directly connect the Garmin GPS to the Mac via a Keyspan USB to serial adapter. The Mux does not support the Garmin proprietary data.
Scott Dillon
Sydney Australia
North Shore 38
CYCA
5
Posts: 1,947
Threads: 284
Joined: April 22, 2005
Reputation:
0
Yes you can connect the GPS and AIS with the Keyspan 4 port adapter. Each then will be using it's own port. /dev/cu.USA.1 and /dev/cu.USA.2, etc.
Select the correct ports in the GPS and AIS panel Settings drawer and the 4800 and 38400 rate respectively.
With that setup you can transfer waypoints,routes,tracks to/fro your Garmin.
If you need DB-9 connectors for either, we offer crimp on ones..
Data Cable
Scott Dillon
Sydney Australia
North Shore 38
CYCA
4
Posts: 152
Threads: 48
Joined: June 3, 2005
Reputation:
0
Is using the 4-port Keyspan adaptor a good solution?
I seem to remember you telling me ages ago that a multiplexer was the way to go.