May 8, 2011 14:18
Yes, that's the way I would do it. The cable and DB9 kits can usually be found at electronic shops like Radio Shack.
The RS232 pinouts may be in your NX2 manual. If not, this site has a wealth of information on the subject:
http://www.lammertbies.nl/comm/cable/RS-232.html
(Typically, you only need 3 wires (pin 2-receive, pin 3-send, pin 5-signal ground).
You may be able to rig up a test before pulling the cable by using a coil of the cable if you can temporarily place the mini close to the NX2.
The RS232 pinouts may be in your NX2 manual. If not, this site has a wealth of information on the subject:
http://www.lammertbies.nl/comm/cable/RS-232.html
(Typically, you only need 3 wires (pin 2-receive, pin 3-send, pin 5-signal ground).
You may be able to rig up a test before pulling the cable by using a coil of the cable if you can temporarily place the mini close to the NX2.
— —••• •••— —
Jon Longworth
Jon Longworth