September 4, 2011 07:51
A couple points:
Set the "Sub Distance" in the "Units" in the iNavX "Preferences" to either "Yds." or "Meters" and the Anchor alarm will use either feet or meters.
The next release of iNavX in regards to the Anchor Alarm:
- Adds the ability to set the distance and bearing to the anchor hence allowing the center point of the anchor alarm to be adjusted.
- Alarm Sound will stop immediately upon press of "Cancel" button or closing Anchor Alarm view.
- Will not trigger the alarm if the GPS position error is large.
- Will be accessible from both the iNavX main menu and from the "Instruments" banner and view setup.
Thanks for the real-world feed back.
Set the "Sub Distance" in the "Units" in the iNavX "Preferences" to either "Yds." or "Meters" and the Anchor alarm will use either feet or meters.
The next release of iNavX in regards to the Anchor Alarm:
- Adds the ability to set the distance and bearing to the anchor hence allowing the center point of the anchor alarm to be adjusted.
- Alarm Sound will stop immediately upon press of "Cancel" button or closing Anchor Alarm view.
- Will not trigger the alarm if the GPS position error is large.
- Will be accessible from both the iNavX main menu and from the "Instruments" banner and view setup.
Thanks for the real-world feed back.
Scott Dillon
Sydney Australia
North Shore 38
CYCA
Sydney Australia
North Shore 38
CYCA