May 5, 2005 09:26
Can receive one channel at a time, by default it is set up to receive channel A.
One can programtically select channel B by sending this NMEA command..
$PNMLC,c*hh<CR><LF>
Where:
c is the channel receive mode as follows:
A = Channel A (channel 1)
B = Channel B (channel 2)
hh = Checksum as defined in NMEA 0183
<CR><LF> = Carriage Return, Line Feed sequence as defined in NMEA 0183
One can programtically select channel B by sending this NMEA command..
$PNMLC,c*hh<CR><LF>
Where:
c is the channel receive mode as follows:
A = Channel A (channel 1)
B = Channel B (channel 2)
hh = Checksum as defined in NMEA 0183
<CR><LF> = Carriage Return, Line Feed sequence as defined in NMEA 0183
Scott Dillon
Sydney Australia
North Shore 38
CYCA
Sydney Australia
North Shore 38
CYCA