December 17, 2010 10:00
How do I connect my west marine ais 1000 to Mac ENC?
|
Thread Rating:
|
December 17, 2010 10:08
You would connect the data cable to a USB adapter such as this one ..
http://www.gpsnavx.com/html/datacable.html
Once that is done, install the linked FTDI driver, plug in the USB adapter to your Mac and start MacENC. Select the port USBSerial-XXX, rate 4800 in the GPS panel Settings drawer. Select "Use GPS Port" in the AIS/RADAR panel Settings drawer.
The AIS1000 will act as both GPS and AIS receiver for MacENC.
http://www.gpsnavx.com/html/datacable.html
Once that is done, install the linked FTDI driver, plug in the USB adapter to your Mac and start MacENC. Select the port USBSerial-XXX, rate 4800 in the GPS panel Settings drawer. Select "Use GPS Port" in the AIS/RADAR panel Settings drawer.
The AIS1000 will act as both GPS and AIS receiver for MacENC.
Scott Dillon
Sydney Australia
North Shore 38
CYCA
Sydney Australia
North Shore 38
CYCA
Browsing: 1 Guest(s)