May 7, 2012 01:26
Hi! I am having difficulty getting iNavX on my iPhone to received the NMEA data stream from MacENC.
It used to work fine. But since i got an iPad (2012) I cannot get the data stream. I am not certain it is connected with the iPad, but it was about that time I noted it had stopped working.
The iPad receives the data stream fine. The iPhone connects, and immediately says 'Connected' but no green data (or any other colour) shows up, and eventually the link disconnects. I have tried it without the iPad connected, in case there is a problem with two listeners, but that makes no difference. I have compared the two 'TCP/IP NMEA Client' windows side-by-side and can see no difference - the same Host TCP/IP address (100.100.100.100), the same Port (2114) and all the other settings the same (other than the iPad-only ones missing from the iPhone, of course).
Any advice or suggestions would be most welcome.
Tony
It used to work fine. But since i got an iPad (2012) I cannot get the data stream. I am not certain it is connected with the iPad, but it was about that time I noted it had stopped working.
The iPad receives the data stream fine. The iPhone connects, and immediately says 'Connected' but no green data (or any other colour) shows up, and eventually the link disconnects. I have tried it without the iPad connected, in case there is a problem with two listeners, but that makes no difference. I have compared the two 'TCP/IP NMEA Client' windows side-by-side and can see no difference - the same Host TCP/IP address (100.100.100.100), the same Port (2114) and all the other settings the same (other than the iPad-only ones missing from the iPhone, of course).
Any advice or suggestions would be most welcome.
Tony